News

  • Well Cementing Services Market Size, Share & Trends Analysis

    Well Cementing Services Market Size, Share & Trends Analysis

    Industry InsightsThe global well cementing services market size was USD 7.44 billion in 2015. The rising energy demand is anticipated to increase the market growth and also urge the E&P companies to raise their investments in onshore and offshore oil & gas reserves. Increasing E&P for r... read more

    Dec 09,2020 Industry News
  • What are the introduction of flame retardants?

    What are the introduction of flame retardants?

    In order to increase the flame resistance of polymer materials, it is mainly used for polymer materials such as plastics, rubber, fibers, etc. Most of these materials are combustible. Especially for plastics, if it is to be used in transportation, construction, electrical equipment, aviation, space... read more

    Dec 07,2020 News
  • Foam coating acrylate copolymer emulsion

    Foam coating acrylate copolymer emulsion

    Foam coating is to add a foaming agent (usually a surfactant) to a higher concentration of finishing working fluid and then use foaming equipment to mix it with air. A processing technology that forms a certain quality of foam, and then uniformly applies the foam to the surface of the fabric throug... read more

    Dec 05,2020 Industry News
  • RF-205A Flame Retardant Liquid

    RF-205A Flame Retardant Liquid

      RF-205A is an enconomical compound flame retardant liquid formulated synergistically with phosphorus and nitrogen. It’s applied to curtain, drapery, velvet, wallpaper, wall cloth, flflocking fabric, carpet and leather. It can be coated on various kinds of blended fabrics, such as cotton, linen, w... read more

    Dec 05,2020 Industry News
  • HDPE is a good material to produce synthetic membrane

    HDPE is a good material to produce synthetic membrane

    High-density polyethylene (HDPE) is a white powder or granular product. It is non-toxic, tasteless, crystallinity is 80%-90%, softening point is 125-135℃, service temperature can reach 100℃; hardness, tensile strength and creep are better than low-density polyethylene; wear resistance, electricity ... read more

    Dec 05,2020 Industry News

Submit feedback